Wire End Vise (Square Plate)
Out of stock
This wire end vise is now non standard and small quantities only are held in stock for existing customers only. The round head vise is now preferred as it allows for countersinking the head into the straining post using a “spade” bit. For more information on the standard version see Wire End Vise – Round Head.
Our wire end vice is inconspicuous and low profile providing for both an aesthetically pleasing and safe fence for your horses. Simple to use and durable our wire end vices are superior to other systems. The one way jaw inside the vise will allow us to tension the wire within the fence rail.
Two wire end vises are used for each end of the rail to attach to the end posts. That is one end vice is used for each 2.5mm high tensile wire within the rail. A straining tool is then used to apply tension to the wire, and therefore the rail, which is maintained by the wire end vice. A gripple tool or alternative brand tool can be used, or you can use ours see Our Straining Tool.
Beware of inferior systems with the large accessories which are unsightly and dangerous to livestock.
How to use wire end vise in horse fence installation
Refer to our installation guide for instructions on straining your Bounce Back® Horse Rail.
Alternatively, the use of our wire end vises is shown on our installation videos Installation Video – Attach the rail to the dead end post and Installation Video – Straining the rail